VintageKustom.com - RDF feed
http://www.vintagekustom.com/FUDforum/index.php
K200B
http://www.vintagekustom.com/FUDforum/index.phpindex.php?t=rview&goto=26029&th=4433#msg_26029
He had installed a brite switch in one of the preamp boards that I provided him and things where fine.
While playing the amp he turned it up louder , played more and then heard a loud pop and lost output, but the strange thing is that the pilot lamp was still responding normal to his playing by dimming which is something I have never seen before!
So far in trouble shooting this issue I had him check the output from the amps RCA jack where he said that there is a screaming loud sound coming out if the jack.
My guess at this point is that one of the preamps is oscillating.
Irish77960 , at this point we neeed to pin down what's going on , and I would say that the thing to do is to unhook the Blue audio output wire from each preamp one at a time to see if atleast one channel is working normal and report back.]]>stevem2017-04-05T12:18:54-00:00Re: K200B
http://www.vintagekustom.com/FUDforum/index.phpindex.php?t=rview&goto=26032&th=4433#msg_26032
Sorry it took me a minute to get this done. So, I plugged it in and turned it on before performing any of the tests. Dang. It worked. Plugged in a bass and sound from all channels. The light still dims a little when a note is hit, bit I could not recreate the same scenario I wrote you about. I'm baffled. There is a good amount of hum, more than my other K200b, but all channels, all tone adjustments, and bride switches working. This amp, along with another that Bill has helped me with are possessed.]]>irish770602017-04-10T21:06:49-00:00Re: K200B
http://www.vintagekustom.com/FUDforum/index.phpindex.php?t=rview&goto=26033&th=4433#msg_26033
When you plug a cable end into the jack the switch opens up and signal can then pass into the preamp.
Your should clean + lube this switch section of each jack.
I do this by wetting up a a thin scrap of plain card board like from a new Shirt package ( no coloring on it) with contact cleaner and drag it back and forth thru the closed switch.
Next with a wetted up Q tip clean up the ID of each jack and where the tip of the cable makes connection in the jack.
Many times you will be stunned at how much dirt and crap gets removed from the ID section of the jack.
On jacks that have been used a lot it also is good to bend the tip connection back out more because it's the side load on the tip connection that forces the ground portion of the jsck onto the ID of the jack.
If this side loading does not take then you get intermittent conduction, loud crackling and hum out of the amp.
Oh , and yes the amp May need new msin can filters, but report back on this first and then I will tell you how to check the filters out.]]>stevem2017-04-11T10:03:17-00:00Re: K200B
http://www.vintagekustom.com/FUDforum/index.phpindex.php?t=rview&goto=26035&th=4433#msg_26035
irish770602017-04-12T15:02:16-00:00Re: K200B
http://www.vintagekustom.com/FUDforum/index.phpindex.php?t=rview&goto=26036&th=4433#msg_26036
If not that's a sign that the amp has issues that likely have not been corrected seing as you blew the fuse, this of course assumes that the fuse that blew on you is the right 3 amp fast blow type.]]>stevem2017-04-12T16:27:07-00:00Re: K200B
http://www.vintagekustom.com/FUDforum/index.phpindex.php?t=rview&goto=26037&th=4433#msg_26037
irish770602017-04-12T19:52:38-00:00Re: K200B
http://www.vintagekustom.com/FUDforum/index.phpindex.php?t=rview&goto=26038&th=4433#msg_26038
Fuse in, all ports jacks and pots squeaky clean. Silent. No hum or buzz. Nothing but guitar sounds.
The lamp situation is just a little weird. It's steady illumination until the volume hits 90%. Then it dims slightly when a note is hit. My guess is the old caps. Although they are working very well now.]]>irish770602017-04-13T01:00:02-00:00Re: K200B
http://www.vintagekustom.com/FUDforum/index.phpindex.php?t=rview&goto=26039&th=4433#msg_26039
It's quite normal for the pilot lamp to dim a lot during playing, even when new this is what happens and is considered normal.
The louder you play the amp , the more the lamp will dim out!
I would say that now your amp has a clean bill of heath, enjoy!!]]>stevem2017-04-13T10:11:25-00:00Re: K200B
http://www.vintagekustom.com/FUDforum/index.phpindex.php?t=rview&goto=26040&th=4433#msg_26040
irish770602017-04-13T18:31:28-00:00