VintageKustom.com - RDF feed
http://www.vintagekustom.com/FUDforum/index.php
Kustom V Mixer ( flat base unit )
http://www.vintagekustom.com/FUDforum/index.phpindex.php?t=rview&goto=27479&th=4731#msg_27479
I am looking for a Kustom V Schematic and Hookup Paper / Book
Any clues out there?..
This mixer sits flat on table and even has a reverb tank installed inside
It has mono " main " and mono " monitor "
It has Echo input 1/4 on the back with others too
It is a 6 input mixer...]]>jammy51522019-09-01T21:39:10-00:00Re: Kustom V Mixer ( flat base unit )
http://www.vintagekustom.com/FUDforum/index.phpindex.php?t=rview&goto=27480&th=4731#msg_27480
stevem2019-09-02T10:11:53-00:00Re: Kustom V Mixer ( flat base unit )
http://www.vintagekustom.com/FUDforum/index.phpindex.php?t=rview&goto=27481&th=4731#msg_27481
Yes... that is part of it.... also a schematic to see why monitor roars when Volumn is increased too...
It needs cleaning and pots need cleaning ]]>jammy51522019-09-02T17:04:05-00:00Re: Kustom V Mixer ( flat base unit )
http://www.vintagekustom.com/FUDforum/index.phpindex.php?t=rview&goto=27482&th=4731#msg_27482
Yes... a schematic too beside the basic setup
The reverb sounds great in this Mixer...
]]>jammy51522019-09-02T17:07:29-00:00Re: Kustom V Mixer ( flat base unit )
http://www.vintagekustom.com/FUDforum/index.phpindex.php?t=rview&goto=27488&th=4731#msg_27488
Does the mixer have a issue besides the scratchy control pot?
If you open it up and make note of the PC board numbers there might be a PC board close to being the same on this site.]]>stevem2019-09-04T10:03:42-00:00Re: Kustom V Mixer ( flat base unit )
http://www.vintagekustom.com/FUDforum/index.phpindex.php?t=rview&goto=27680&th=4731#msg_27680
It has a Mono Main / 1/4 input...
It has a Mono Monitor Main 1/4 jack input....
It has an Echo 1/4 jack input...I can figure this all these inputs but it has other inputs too...
]]>jammy51522020-02-22T21:13:36-00:00Re: Kustom V Mixer ( flat base unit )
http://www.vintagekustom.com/FUDforum/index.phpindex.php?t=rview&goto=27682&th=4731#msg_27682
These where very basic mixers and I don't even think that there main and monitor outputs where balanced low impeadance, but I could be wrong after all these years!
Other then the issue that it seems your monitor section of the mixer has I can't see what your questioning in regards to running the unit.
You just send the mixers output into a power amp and then the power amp out to speaker!
Many power amps these days have a combo type input jack that accepts both a XLR input or a 1/4' TRS male end.
You would use the 1/4" input on the combo jack, the only thing is that if I am right about the mixer not being low impeadance then your going to have to Crank the mixer up more as running a unbalanced signal into a balanced input power amp will knock 6 db off the the mixers output level.]]>stevem2020-02-24T12:19:21-00:00Woodson W150-2 GuitarAmplifier
http://www.vintagekustom.com/FUDforum/index.phpindex.php?t=rview&goto=27727&th=4731#msg_27727
This amp uses the same circuitry as the Kustom amps and was another part of the series like Plush, Kasino, Kustom etc
I am looking to get a schematic if anyone knows where that can be found]]>jammy51522020-03-12T20:44:54-00:00