VintageKustom.com
VintageKustom.com is your source for literature and information on the tuck-and-roll vintage Kustom amps from the 60's and 70's, as well as their related products such as guitars and organs . We provide a webboard for help with kustom gear history, technical information and repairs as well as discussions with other collectors.

Home » VintageKustom.com » Repairing Kustom Amps » Kasino U 100 ? & Hola!
Show: Today's Messages :: Polls :: Message Navigator
Return to the default flat view Create a new topic Submit Reply
Re: Kasino U 100 ? & Hola! [message #25527 is a reply to message #25525] Fri, 09 September 2016 00:40 Go to previous messageGo to previous message
chicagobill
Messages: 2005
Registered: April 2003
Senior Member
If as you say the red wire was disconnected, the positive side of the power supply was missing from the amp when you turned it on. This would cause the power amp to shift the speaker output to the negative side of the power supply, which probably caused the fuse to blow. What damage was caused by this is unknown and really unpredictable. The best way to find out is to test the parts.

If you have replaced the fuse and turned the amp back on, if the bridge rectifier was damaged, the new fuse would blow. Same for the power amp transistors, well most of them at least.

If you can power up the amp, leave the speaker disconnected for now until you check for voltage on the speaker jack. Measure the dc voltages at the two main filter caps. The red wire is the positive side and the green is the negative side. You should read somewhere around 40 dc volts pos and neg. Read the dc voltage across the speaker jack. You should get a reading of less than 1/2 dc volt at the speaker jack. A few millivolts is more normal there.

All of this assumes that you have the equipment and skill set to work on a live amp.Remember that a live amp can do you physical harm, so if you don't feel comfortable in making these tests, then don't.
[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: K-200B-2 reverb/tremblo
Next Topic: K-100-2 wireing
Goto Forum:
  

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Thu Jun 06 06:25:02 EDT 2024