Home » VintageKustom.com » Comment Board » size of K250-3

Show: Today's Messages :: Polls :: Message Navigator

size of K250-3 [message #8731] Sun, 08 July 2007 15:16   davohilts Messages: 40 Registered: August 2006 Location: Portland, OR Member Hi all, I'm wondering if anyone knows the inside dimensions of the tuck and roll box for a K250-3?? thanks Report message to a moderator

Re: size of K250-3 [message #8733 is a reply to message #8731] Mon, 09 July 2007 07:04   stevem Messages: 4742 Registered: June 2004 Location: NY Senior Member Not off the top of my head(pun intended!) but I can post it on tuesday if no one else has got you covered by than. Report message to a moderator

Re: size of K250-3 [message #8734 is a reply to message #8733] Mon, 09 July 2007 08:16   davohilts Messages: 40 Registered: August 2006 Location: Portland, OR Member thanks! i'm hoping to pick one up on ebay but i'm not sure if it is the right size. Report message to a moderator

Re: size of K250-3 [message #8741 is a reply to message #8731] Wed, 11 July 2007 06:34   stevem Messages: 4742 Registered: June 2004 Location: NY Senior Member HI, these measurements where taken on the front side of the case, from the edge of the tuck&roll to the other edge, and should be within 1/8" slant face K250(all K250S) 5.5"height 20 7/8" wide Slant face K150 (ALL K150s) 5.5 height 17 wide. If the case you are checking out is slant face, and both taller and wider, than its for a K300 or K600 PA head. Report message to a moderator

Re: size of K250-3 [message #8743 is a reply to message #8741] Wed, 11 July 2007 08:29   davohilts Messages: 40 Registered: August 2006 Location: Portland, OR Member thanks for the dimensions! I really thank you!!! Report message to a moderator

Previous Topic:	Model 4-12 L 70's cabinet
Next Topic:	K250-4 Project

Goto Forum:

- VintageKustom.com  Comment Board  Replacement Part Suggestions  Repairing Kustom Amps- Classified Ads  For Sale  Wanted- FUDforum Questions & Problems  Questions & Problems about FUDforum