VintageKustom.com
VintageKustom.com is your source for literature and information on the tuck-and-roll vintage Kustom amps from the 60's and 70's, as well as their related products such as guitars and organs . We provide a webboard for help with kustom gear history, technical information and repairs as well as discussions with other collectors.

Home » VintageKustom.com » Replacement Part Suggestions » Licon switch replacement
Show: Today's Messages :: Polls :: Message Navigator
Return to the default flat view Create a new topic Submit Reply
Re: Licon switch replacement [message #14522 is a reply to message #14521] Wed, 06 October 2010 17:46 Go to previous messageGo to previous message
dndemattia is currently offline  dndemattia
Messages: 6
Registered: September 2010
Location: USA
Junior Member

Both switches have the LED built in and are the same type discussed on this forum from Mouser. The LED in the Power switch is fine. Will check for shorts or errors in wiring on my part on the polarity switch LED (seemed pretty straight forward). What is the voltage supposed to be at the poliarity switch old pilot light? It looks like it comes right off the bridge rectifier. Just a general question - Do I really need the polarity switch? If not, how do I handle the .022 cap on the incoming AC power? Thanks again for all the help!

[Updated on: Wed, 06 October 2010 17:53]

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Kustom K200D Bass Guitar tuners?
Next Topic: Sidewinder Diode CR1 & CR2 replacement (part no: 007-6011-00)
Goto Forum:
  

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Sun Jun 09 23:27:32 EDT 2024