VintageKustom.com
VintageKustom.com is your source for literature and information on the tuck-and-roll vintage Kustom amps from the 60's and 70's, as well as their related products such as guitars and organs . We provide a webboard for help with kustom gear history, technical information and repairs as well as discussions with other collectors.

Home » VintageKustom.com » Repairing Kustom Amps » 250-4 (got it burnt up to repair on my bech)
Show: Today's Messages :: Polls :: Message Navigator
Return to the default flat view Create a new topic Submit Reply
Re: 250-4 [message #28620 is a reply to message #28618] Thu, 23 June 2022 17:17 Go to previous messageGo to previous message
kb0rex is currently offline  kb0rex
Messages: 33
Registered: June 2022
Member
well I typed a long reply but apparently got logged out. So here is the short retyped version. I usually use the bulb limiter on any items I get into for repair. also a variac. On this on I replaced the worst first, the output's , which were shorted the drivers also and there 95.3 and 681 and .51 5 watters. I also replaced q6 and 7. So q4-13 have been replaced and the resisters associated with them. I also replaced cr1 and cr2 with 4007s to try and cool power section as its working now but hot. I have also at this time repaired the effects board to function and now this amp passes signal end to end with good volume. I just can't seem to get the power amp section to balance. I have not tried the diff amp q1 and q2 or changed q3. With power amp disconnected I have good +- rails at 40.3volts. This drops to 37 with power amp inline. So I am at a loss where to got.... I suspect the bias but don't know this amp well enough. Thanks for tossing me a life line.

Doug
Sad
[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: K200 Bright Channel is ALIVE...
Next Topic: Krossroad 500 "pops" when powered off
Goto Forum:
  

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Fri Jun 07 11:02:16 EDT 2024