Reverb tank For a Gibson Gibson Goldtone ? [message #14215] |
Thu, 19 August 2010 11:39 |
Kochens
Messages: 80 Registered: April 2009 Location: Denmark
|
Member |
|
|
Hello Kustom members,
I know it`s maybe not the Forum to discus this matter, but I have problem to get info on the issue.I need a accutronic reverb for my Gibson Super Goldtone Ga-30RVH.When I bought the amp used, it came without the reverb tank.In the amp-manual it is described as a 3 spring accutronic unit (type 8, ?) I have a schematic ,but I don`t understand it.
Hope you can help.
Peter Koch
|
|
|
|
|
|
Re: Reverb tank For a Gibson Gibson Goldtone ? [message #14220 is a reply to message #14219] |
Fri, 20 August 2010 12:03 |
chicagobill
Messages: 2005 Registered: April 2003
|
Senior Member |
|
|
You need either a type 8 or type 9 tank. The 8 is the shorter one and 9 is the full length one.
I don't know how it mounts in the case, so you will need to figure out that part of the equation.
The schematic for your amp shows a tube driven reverb circuit, so the input transducer needs to be 10 ohm. The recovery circuit is again a tube stage, so just like a Fender tank the output transducer needs to be 2575 ohm.
So the tank code number should be 8 or 9 A B ? ? 1 ?
My educated guess would be 8AB2C1D.
I hope this helps.
|
|
|
|
|