Home » VintageKustom.com » Comment Board » need inside pic of 200 series!!!! Help!!!

Show: Today's Messages :: Polls :: Message Navigator

need inside pic of 200 series!!!! Help!!! [message #3970] Tue, 30 March 2004 18:19 Craig Messages: 1 Registered: March 2004 Junior Member I have a k200a-5 p.a. head, that I had a friend offer to "clean up" for me. Well, to make a long story short............... he took it apart and cant remember where some of the wires went. so........... I need a inside picture of one (or one similar) with the reverb unit out of the way. If anyone could help it would be very much apprieciated. I will pay $$ Thanx Report message to a moderator

Re: need inside pic of 200 series!!!! Help!!! [message #3977 is a reply to message #3970] Thu, 01 April 2004 07:58   stevem Messages: 4738 Registered: June 2004 Location: NY Senior Member Hi,Its not much of a problem.Take your 2 reverb cords and plug them into the RCA jacks in the amp, You will have to work with the amp on so before hand you may want to take some duct tape and try to cover up the fuse block, the on/off switch and the tops of the 2 big filter cans, so you can work safe. With the amp on, and the other ends of the reverb cords not shorting to anything, turn up a channel and turn up the reverb to that channel. Take one of the cords and with your finger touch the tip of the cord. You should hear a buzz from one of them, just like if you had your guitar cord unpluged with the amp on and the volume up. The cord you get a buzz from goes to the jack marked output on the reverb pan. If you plug the cords in wrong you will not harm the amp but you may get a loud squeel and the reverb will not work. This assumes that you pan is OK . The volume you hear when touching the tip of the RCA jack will depend on the volume of the channel and the reverb level for that channel. The only voltage that can harm you is the A/C voltage on the fuse on the back wall and the on /off swt. Report message to a moderator

Re: need inside pic of 200 series!!!! Help!!! [message #3978 is a reply to message #3977] Thu, 01 April 2004 19:58 Anonymous Thanks for the help but, I need to know the arrangment of the wires that connect to the filter cans............ I already fried one wire. Hope you can help!! Report message to a moderator

Previous Topic:	Kasino 800
Next Topic:	What is this PA?

Goto Forum:

- VintageKustom.com  Comment Board  Replacement Part Suggestions  Repairing Kustom Amps- Classified Ads  For Sale  Wanted- FUDforum Questions & Problems  Questions & Problems about FUDforum