VintageKustom.com
VintageKustom.com is your source for literature and information on the tuck-and-roll vintage Kustom amps from the 60's and 70's, as well as their related products such as guitars and organs . We provide a webboard for help with kustom gear history, technical information and repairs as well as discussions with other collectors.

Home » VintageKustom.com » Repairing Kustom Amps » Kustom 200 B1 blowing fuses (200 B1 circuit restoration help needed)
Show: Today's Messages :: Polls :: Message Navigator
Return to the default flat view Create a new topic Submit Reply
Kustom 200 B1 blowing fuses [message #21094] Sun, 10 August 2014 09:22 Go to previous message
Tone Meister is currently offline  Tone Meister
Messages: 42
Registered: August 2014
Location: NC
Member
Hi, using my first post seeking information on a 200 B1 that is/was blowing fuses. Amp serial number is 59412, no tremolo or reverb. Power amp board is PC703 but I haven't pulled either preamp board so I haven't yet determined exactly which boards they are.

The amp had been sitting for years and was blowing fuses upon power up. Found a shorted driver transistor (38736 = RCA 40409) and was able to source some NOS replacements for all the driver transistors, RCA 40409 and 40410.

There is at least one output that is shorted, so I want to just refurbish the power board and both preamp boards while I have it open. I plan to use 2N3055 replacements unless there is a better choice these days. Please don't suggest the NTE130MP because they cost 20X what I'd have to pay for the 2N3055s.

The main filter caps are good, but I do want to swap out all the tantalum caps on all the boards and all the driver and output transistors, plus the 1 ohm 5 watt resistors. Is there a definitive parts list for these amps, or does someone have parts suggestions for a solid, basic circuit overhaul without going too far overboard? I just want to make the amp functional and reliable.

Any parts suggestions or technical recommendations are welcome.

Thanks in advance.

-Stan

[Updated on: Sun, 10 August 2014 10:35]

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: K200 Repair & Transistors
Next Topic: K 100 8 Kustom Amp
Goto Forum:
  

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Wed Jun 12 13:53:20 EDT 2024