VintageKustom.com
VintageKustom.com is your source for literature and information on the tuck-and-roll vintage Kustom amps from the 60's and 70's, as well as their related products such as guitars and organs . We provide a webboard for help with kustom gear history, technical information and repairs as well as discussions with other collectors.

Home » VintageKustom.com » Comment Board » Looking for info on a Kustom K 100C-8
Show: Today's Messages :: Polls :: Message Navigator
Return to the default flat view Create a new topic Submit Reply
Re: Looking for info on a Kustom K 100C-8 [message #12061 is a reply to message #12060] Tue, 29 September 2009 23:04 Go to previous messageGo to previous message
pleat is currently offline  pleat
Messages: 1452
Registered: June 2004
Location: Belding, Mi
Senior Member
LesS, I see where the 1971 date on the one chart might be confusing, as I haven't scanned every page of 7 kustom manuals I have. Figure 10 does show two speakers wired in parallel but does not say what diameter or impedance the speakers are. Matching that to SC speaker wiring diagram I sent with no drawing date matches a parallel schematic.
As far as the K100 SC's I've owned didn't have a speaker jack on the back installed from the factory, but a fellow collector in SC just got a K100SC-8 2x10 in silver that he sent a photo of front and back. The photo on the back shows two jacks on the back, factory power switch, just below it labeled with a green dymo marker says EXT speaker, below it labeled in green dymo tape says Footswitch. It's hard to tell if the footswitch jack has the washer that the factory used to label what jacks were what. I'm gong to email him and have him take some photos of the inside when he replaces the power cord with a new grounded power cable and installs a replacement cord wrap.
Don
[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Did Kustom use particle board on the K250 cabinet?
Next Topic: Thoughts after replacing caps and drivers
Goto Forum:
  

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Wed Jun 05 22:58:36 EDT 2024