VintageKustom.com
VintageKustom.com is your source for literature and information on the tuck-and-roll vintage Kustom amps from the 60's and 70's, as well as their related products such as guitars and organs . We provide a webboard for help with kustom gear history, technical information and repairs as well as discussions with other collectors.

Home » VintageKustom.com » Comment Board » What I always wished for (200B1 and 2 2k+1H)
Show: Today's Messages :: Polls :: Message Navigator
Switch to threaded view of this topic Create a new topic Submit Reply
What I always wished for [message #9709] Sat, 20 September 2008 17:21 Go to next message
danjc is currently offline  danjc
Messages: 1
Registered: August 2008
Junior Member
I'm new here as far as posting, but I've been reading for months. Heres my story, after 30 (or 40)years of growing older, I have decided to pick my bass back up. It was nothing special and had no strings, so while I was at the G C looking for strings I grabbed a Fender Mustang bass.(try and explain that to your wife). I knew that Ihad from the 70's aFender silverface bassman. Found it looked at it and decided the safe thing to do was take it to Gravity Strings before I plugged it  in. While it was being checked, I found 2 Kustom black T@R speakers on c list(I had sold my Fender cabinet). These are equiped with 2 15" KEI speakers and one horn. The plate says Kustom Electronics the model number is 2K+1HP. the serial numbers are 40696 and 40689. The only markings on the horns are SA422. The speaker are KEI 15" black with square magnets and their part #038502800 8 ohm the serial numbers are 40696 and 40689 with a silver background on the plate not black. Then to make a long story short (prbably to late) I FOUND A k200b1  black t@r are they comptable.
Re: What I always wished for [message #9710 is a reply to message #9709] Sat, 20 September 2008 22:51 Go to previous message
LesS is currently offline  LesS
Messages: 477
Registered: December 2002
Senior Member
Hi,
The K200B-1 output is 4 ohms or higher.

If each cabinet has two 8 ohm speakers (plus the horn)then the impedance of each cabinet is 4 ohms.

So with your K200 amp you can use:
1) one cabinet (4 ohms impedance), or
2) both cabinets connected in series (8 ohms impedance)

-LesS
  Switch to threaded view of this topic Create a new topic Submit Reply
Previous Topic: Frankenstein Reverb question
Next Topic: Kustom "200"
Goto Forum:
  

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Fri Jun 07 02:18:32 EDT 2024