VintageKustom.com
VintageKustom.com is your source for literature and information on the tuck-and-roll vintage Kustom amps from the 60's and 70's, as well as their related products such as guitars and organs . We provide a webboard for help with kustom gear history, technical information and repairs as well as discussions with other collectors.

Home » VintageKustom.com » Repairing Kustom Amps » K200 B4 (No Volume...A little smoke! Help needed!)
Show: Today's Messages :: Polls :: Message Navigator
Return to the default flat view Create a new topic Submit Reply
K200 B4 [message #26801] Tue, 17 July 2018 23:08 Go to previous message
sskydiver1 is currently offline  sskydiver1
Messages: 27
Registered: December 2008
Location: Texas
Junior Member
I plugged in my K200B4 tonight for it's 90 day workout (wish I had time to play it it more often!) -

and I was hearing way more way more of the "white noise" (which in retrospect may have been 120v hum) than usual.

I went ahead and started playing through it and checked out all the functions, which all seemed to work - and the volume was as loud as usual.

I did notice that when I switched the "Selective Boost" knob it was making quite a loud popping noise when switching positions - but the frequencies were changing as they should.

Within 5 minutes, the amp volume dropped WAY down and the white noise/hum went away. You could still hear the guitar - but the volume was low bedroom volume at best. All the amp functions still seemed to work just fine, but no volume so to speak. When I used my flashlight to look at the back I saw a little smoke and turned the amp off right away.

Also - at the new very low bedroom volume - the amp gets very distorted as if there is a fuzz box on it when you turn the volume past halfway (I turned the amp on again to see if anything had changed - which it hadn't)

Any thoughts? Wondering/hoping it might be a part I could install with my intermediate soldering chops - and if not - can anyone recommend a tech who could fix her up and keep her going? I am hopeful that it is not TOO big an issue - it would be a shame to let this amp go into the scrap heap of history.

Final question - is this something that a good electronics and amp tech can fix - or do you need very specific experience and rare parts to fix it?

Many thanks for any response!

Derek

[Updated on: Tue, 17 July 2018 23:27]

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: KUSTOM VIII S-R-S amplifier
Next Topic: K200B-2 Both Preamps bad?
Goto Forum:
  

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Fri Jun 07 07:36:45 EDT 2024