VintageKustom.com: Replacement Part Suggestions

Home » VintageKustom.com » Replacement Part Suggestions » PA mount bracket

Show: Today's Messages :: Polls :: Message Navigator

Re: PA mount bracket [message #22254 is a reply to message #22253]

Wed, 28 January 2015 05:42

pleat
Messages: 1452
Registered: June 2004
Location: Belding, Mi

Senior Member

The original stands were one piece and didn't break down into 3 pieces for travel. Later Kustom made the stands to break down into left and right side, and depending which head the stand was for, (K200, K300, K400, and K600) PA the center bar is a different length.

For bolting the stand to the head, I set the PA on the floor, bolt the stand to head with the stand on the floor as well, leave the mounting bolts loose, and pick up the amp head and let the stand swing until it is upright, tighten the bolts with the angle you want the faceplate to sit.

For tear down, loosen the bolts, walk the head down to the floor and remove the bolts and the remove the center section of the stand.

One person job, and you don't have to try and have someone hold up the head while you insert the bolts and try and tighten the bolts.
pleat

Report message to a moderator

[Message index]

		PA mount bracket By: twault on Tue, 27 January 2015 18:03
		Re: PA mount bracket By: Iowa Boy on Wed, 28 January 2015 00:44
		Re: PA mount bracket By: pleat on Wed, 28 January 2015 05:42
		Re: PA mount bracket By: twault on Wed, 28 January 2015 14:21
		Re: PA mount bracket By: sunnhead on Sun, 01 February 2015 11:16

Previous Topic:	Kustom Badge
Next Topic:	Kustom 2X15 speakers

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Thu Jun 06 07:31:20 EDT 2024