| K 100 2 questions [message #10009] |
Thu, 27 November 2008 09:56  |
jrbick
Messages: 4
Registered: November 2008
Location: PA
|
Junior Member |
|
|
Hello All,
I'm new to your forum, and I think it is Great!
I have mostly old Fender amps, but I recently acquired a K 100 2 guitar head with a 2 x 12 T&R cabinet (Jensens). The amp works pretty well, but I would like to find a schematic to see if there have been any changes made, and correct them if needed.
I also have 2 other T&R cabinets. A 2 X 15 (C.T.S.) that sounds great with this amp, and a 4 X 12 (CEI) that I have swiped the port tubes from, to replace a broken one on the 2 X 12 cab. I was wondering if there is anyone that knows of a source for replacement port tubes. I have searched a few Internet sites, but can’t find any 2.5 inch ports. I would like to find something close to the original type, buy since this cab is a little beat up; I think I will be getting rid of it in the near future, so I’m not too picky.
Any help with these two questions would be appreciated.
John
jb
[Updated on: Thu, 27 November 2008 10:04] Report message to a moderator |
|
|
|
| Re: K 100 2 questions [message #10011 is a reply to message #10009] |
Thu, 27 November 2008 18:55  |
LesS
Messages: 477
Registered: December 2002
|
Senior Member |
|
|
You might want to check with the company with this ebay auction.
ebay auction number 260322631776
item: 3 x 4" CHROME PLATED PLASTIC PORT FOR SPEAKER SUB BOX
The port tube in this auction is too big (3" ID, 4 1/4" flange) but they might can get a smaller one.
K100 cabinet port tubes are: (2 1/2" ID, 3 1/2" flange)
K200 cabinet port tubes are: (3 1/2" ID, 4 1/2" flange)
|
|
|
|
VintageKustom.com
Search
Help
Members
Register
Login
Home
