Home » VintageKustom.com » Comment Board » PA Problem

Show: Today's Messages :: Polls :: Message Navigator

PA Problem [message #2850] Fri, 20 June 2003 21:14 Anonymous I have been playing on 2 k-100 pa heads to 2-4-12" pa columns using 1-right and 1-left Great but i am down to 1 amp now(haven't got the other fixed yet) so the question is how do i use 4 columns with 2 outputs. Will a y-cable do the trick or am i is that too muck load. Haven't done anything yet but would rather find out if i am creating my more problems Report message to a moderator

Re: PA Problem [message #2852 is a reply to message #2850] Sun, 22 June 2003 08:19 QModer Messages: 413 Registered: June 2003 Senior Member Unfortunally you will have to wait until the output is fixed or look at some another Pa amps out jacks are hooked up or this will lead you to an out of blanced ohm load and bad problems. If you grow tired of do wiring problems. Give me an email and then I'll but the wiring headache. Good luck friend. Report message to a moderator

Re: PA Problem [message #2854 is a reply to message #2850] Mon, 23 June 2003 07:49   stevem Messages: 4738 Registered: June 2004 Location: NY Senior Member Hi, to continue to use 4 cabs, you will have to make a adapter to wire to pairs in series.The hot goes into the the tip of a 1/4 " jack the low side comes out and goes to the tip of the next cabs input jack, the low comes out. and that low and hot go to a male 1/4" plug. when you have done that to both pairs of cabs (2 on each side) you than plug them both into the amp the normal way. Report message to a moderator

Re: PA Problem [message #2856 is a reply to message #2854] Mon, 23 June 2003 09:36 C4ster Messages: 686 Registered: June 2001 Location: Mukwonago, WI (Milwaukee... Senior Member Series-parallel combinations are acceptable however, the 4x12 columns are 8 ohm cabinets and you will end up with 8 ohms total with the 4 columns and the output will drop for the total combination to about 30 watts or so. That would be down from the 100 watts the 2 K100's would put out. Conrad Report message to a moderator

Re: PA Problem [message #2857 is a reply to message #2856] Mon, 23 June 2003 14:02 Anonymous thanks for the help i sprayed contact cleaner on pots,wiggled some componets and did not find anything put it back together and hasn't missed a lick. i guess there was a bad connection thanks again greg Report message to a moderator

Re: PA Problem [message #2862 is a reply to message #2854] Mon, 23 June 2003 21:55 QModer Messages: 413 Registered: June 2003 Senior Member Sounds like they've got you covered partner. Report message to a moderator

Previous Topic:	Fake Kustoms
Next Topic:	stanley clarke concert

Goto Forum:

- VintageKustom.com  Comment Board  Replacement Part Suggestions  Repairing Kustom Amps- Classified Ads  For Sale  Wanted- FUDforum Questions & Problems  Questions & Problems about FUDforum