VintageKustom.com: Replacement Part Suggestions

Home » VintageKustom.com » Replacement Part Suggestions » KB150-1 T'n'R Sleeve/Case (Info Required...)

Show: Today's Messages :: Polls :: Message Navigator

KB150-1 T'n'R Sleeve/Case [message #27910]

Tue, 27 October 2020 12:15

HarrySeven
Messages: 2
Registered: October 2020

Junior Member

Hiya.

I'm based in the UK and have just acquired a k150-1 amp head, but it's missing it's Tuck 'n' Roll sleeve/case.

I just wondered - are any other sleeves/cases interchangeable, size-wise?

Thanks! Smile

Report message to a moderator

Re: KB150-1 T'n'R Sleeve/Case [message #27911 is a reply to message #27910]

Tue, 27 October 2020 12:24

stevem
Messages: 4745
Registered: June 2004
Location: NY

Senior Member

The metal face K150 non combo head was a one of a kind size case.
In all likelihood you will have to make a case or if your lucky and find a used K150 combo cabinet then you could cut the speaker section off it and atleast have most of the case with its T & R covering!

[Updated on: Tue, 27 October 2020 12:25]

Report message to a moderator

Re: KB150-1 T'n'R Sleeve/Case [message #27912 is a reply to message #27911]

Tue, 27 October 2020 14:11

HarrySeven
Messages: 2
Registered: October 2020

Junior Member

Thanks for the swift response. Smile

Damn, that's a shame - I was hoping I could pick something up second-hand.

Not a problem, though - fabricating a sleeve should be quite straightforward...

Report message to a moderator

Re: KB150-1 T'n'R Sleeve/Case [message #27913 is a reply to message #27910]

Wed, 28 October 2020 05:37

stevem
Messages: 4745
Registered: June 2004
Location: NY

Senior Member

Well you never know , you might find a badly blown up one that's not worth fixing and commander the cabinet from that!

The 4 machine screws that you will need to hold it into the cabinet you make are 10-32.

[Updated on: Wed, 28 October 2020 05:40]

Report message to a moderator

Previous Topic:	200A vs 200B
Next Topic:	cheap casters

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Jun 08 03:39:32 EDT 2024