missing foot switch jack [message #13377] |
Sun, 11 April 2010 16:21 |
dinsdale
Messages: 3 Registered: April 2010
|
Junior Member |
|
|
need help re-wiring Kustom K200B-2. foot switch jack is missing, & reverb & tremolo were bypassed. on PC303 board, brown wire (reverb) & grey wire (trem) are connected to each other near short blue wire connected to blue wire which goes to amp board. need to re-wire effects into the circuit with or without the foot switch jack. please advise.
thanks,
dinsdale
|
|
|
Re: missing foot switch jack [message #13378 is a reply to message #13377] |
Mon, 12 April 2010 06:05 |
stevem
Messages: 4772 Registered: June 2004 Location: NY
|
Senior Member |
|
|
The K200 models only need a foot switch to remotly turn off the effects once on, the tan and gray wires should never be tied together so I can not say if any harm has beed done to the two effects circuits.
To reinstall a foot switch jack on the amp you will need a stereo TRS ( tip, ring sleve)phone jack.
The tan wire will go to the lug that will make the connection with the tip of the 1/4" TRS foot switch plug.
The gray wire will go to the lug that makes the connection to the sleve of the 1/4" foot switch plug.
If you need a phone jack for the amp, a Mouser electronics part number 502-12B switchcraft phone jack is what the amp originally had from the fectory.
[Updated on: Mon, 12 April 2010 06:07] Report message to a moderator
|
|
|
|
|
|