VintageKustom.com: Comment Board » K50 SC Combo impedance

Home » VintageKustom.com » Comment Board » K50 SC Combo impedance

Show: Today's Messages :: Polls :: Message Navigator

K50 SC Combo impedance [message #29008]

Tue, 28 March 2023 14:20

rodak
Messages: 513
Registered: October 2001
Location: Georgia

Senior Member

My K50 SC Combo has 1 12" 8ohm speaker. From an older thread I found here, it seems 8 ohms was typical for 1-speaker combos. Is the K50 amp able to safely drive 4 ohm load, or is 8 ohms the minimum?

I'm thinking of putting "speaker out/speaker in" jacks accessible from the outside. Can anyone recommend a source for small, round jack plates marked with "8 ohms" or "4 ohms"?

www.combo-organ.com

Report message to a moderator

[Message index]

		K50 SC Combo impedance By: rodak on Tue, 28 March 2023 14:20
		Re: K50 SC Combo impedance By: pleat on Tue, 28 March 2023 20:14
		Re: K50 SC Combo impedance By: stevem on Wed, 29 March 2023 07:01
		Re: K50 SC Combo impedance By: rodak on Wed, 29 March 2023 09:56
		Re: K50 SC Combo impedance By: stevem on Wed, 29 March 2023 11:27
		Re: K50 SC Combo impedance By: rodak on Wed, 29 March 2023 15:35

Previous Topic:	New Reverb Tank Question
Next Topic:	Audio Power Module KPN 200 -0167 in X2-15 B

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun Jun 09 01:03:53 EDT 2024