Need measurements for a K100 head case [message #20558] |
Mon, 05 May 2014 17:53 |
braud357
Messages: 154 Registered: July 2010 Location: Louisiana
|
Senior Member |
|
|
Could anyone please help me - I am in need of the dimensions of a K100 head case - especially the measurements of the front opening and the overall depth. Thanks in advance !!
|
|
|
Re: Need measurements for a K100 head case [message #20603 is a reply to message #20558] |
Fri, 09 May 2014 18:37 |
stevem
Messages: 4772 Registered: June 2004 Location: NY
|
Senior Member |
|
|
The case is made of I 1/2" ply.
The width of the inside rear is 19 1/8 th
The inside is 6 1/2" tall.
The inside depth is 10 inches, this is Measured from the inside of the fronts 3/4" smaller frame.
The front frame is 1/2 ply that is 3/4" tall all the way around the front.
This will let you I have 10 two inch wide pleats on top and four pleats of two inch down each side.
Wait, I need to I look again, I do not know if that front frame is set inside the case, or if the frame is 1 1/2" tall and set on the face of the case.
I will check and post back in the morning for ya.
[Updated on: Fri, 09 May 2014 18:41] Report message to a moderator
|
|
|
|