Today's Messages (on)  | Unanswered Messages (off)

Forum: Comment Board
 Topic: Problem
Problem [message #29257] Mon, 03 June 2024 06:02
stevem is currently offline  stevem
Messages: 4742
Registered: June 2004
Location: NY
Senior Member
I need to apologize to those I have not responded to in a few days.

On Thursday night my iPhone got updated and since then when I log into this site near everything is whited out and I can see nothing.
I had to wait until now to come back to work and use my iPad on  the company's WiFi.

Report message to a moderator

 Topic: 2-15 B Ports Blocked
Re: 2-15 B Ports Blocked [message #29258 is a reply to message #29256] Mon, 03 June 2024 06:14
stevem is currently offline  stevem
Messages: 4742
Registered: June 2004
Location: NY
Senior Member
Is the 250 head one tuck & roll pleat wider then the speaker cab?

Note that pictures can not be posted to this site.

Report message to a moderator

Forum: Repairing Kustom Amps
 Topic: Kustom Studio 4V - Schematic needed
Re: Kustom Studio 4V - Schematic needed [message #29259 is a reply to message #29255] Mon, 03 June 2024 06:26
stevem is currently offline  stevem
Messages: 4742
Registered: June 2004
Location: NY
Senior Member
Go to MusicParts.com, they list the schematic there.
You can buy right there on line and it will load to your computer so you can print it off.

Here's a guess as to what happened to the amp.
A quad of EL34s need 2.5 amps more of heater current then does a quad of 6l6tubes .
This means that the power transformer likely ran so hot that it shorted out and burned up in smoke.

Please report back with your findings and if you need help.
I quick way to test for a major short is to pull all the tubes out and install a 1 amp fuse.
If  that fuse blows at power up or when the amp is taken out of standby then you have a major short.

Report message to a moderator

Re: Kustom Studio 4V - Schematic needed [message #29260 is a reply to message #29259] Mon, 03 June 2024 08:47
electrip_flip is currently offline  electrip_flip
Messages: 2
Registered: May 2024
Junior Member
Hello stevem,

already ordered the schematics.
No fuses dead.
Both PT and OT are fine.
Humdinger resistors literaly disappeared and left a black area.
Funny is Tubes are still heating.
10R Kathode resistors are gone on two tubes.

I expect only minor damages but I have to check those driver bjts.
One connector is missing. Wires were soldered on.

I have to order some parts and a set of 6L6.
Unit is set up for 220V mains,
will set up for 240V and then check heater voltage.
HT unloaded was 527V DC, 383 AC @233V mains

Will need some days for Progress.
Thanks for your Support.

electripflip

Report message to a moderator




Current Time: Mon Jun 03 11:32:43 EDT 2024
.:: Contact :: Home ::.

Powered by: FUDforum 3.1.3.