bpmadsx Messages: 30 Registered: December 2014 Location: Jenkins,KY
Member
chicagobill wrote on Wed, 17 December 2014 15:23
It sounds like you need to remove the other board and resolder whatever is loose there as well. That should fix the signal cutting in and out.
Remove the bulb from the holder and see if there is a number or voltage rating stamped or printed on the base of the bulb. The correct bulb is a #1829.
Bulb in the amp right now is a 1847 Chicagobill
also i have touched up quite a bit of original soldering, and double checked for loose connections on Pc1400, pc1500, and Pc900