refurbing a 250 [message #17357] |
Sat, 11 August 2012 14:38 |
kthazard
Messages: 2 Registered: August 2012 Location: Near Nashville TN
|
Junior Member |
|
|
I am refurbing a 250 that was my late father's amp.I am not too concerned with historical accuracy but more the funtionality. Amp works, but unfortunatly, someone stole the pedals when it was last used at a gig. (I hope(sarcasm)they made a small fortune selling them.)Now I am looking to build a 4-button replacement pedal and wah. After reading several posts here I am assuming the wah is a standard potentiomiter pedal with a 10 k ohm pot in it? The four button pedal sounds simple enough to construct if I had the schematics. Also, where could I buy one of those 6 pin connectors? Is it something standard that say radio shack or an electronics parts store would stock? Would an old Vox amp 6 pin connector work? Once I can test the effects, I am sure I will find more things to repair. Thanks for any and all help.
|
|
|
|
|