VintageKustom.com: Replacement Part Suggestions

Home » VintageKustom.com » Replacement Part Suggestions » Selectone pre-amp PCB

Show: Today's Messages :: Polls :: Message Navigator

Selectone pre-amp PCB [message #13380]

Mon, 12 April 2010 12:57

RobbieNuke
Messages: 66
Registered: October 2006
Location: Baltimore

Member

Does anyone know where I might find a replacement PCB for a KUSTOM K200B6. This is the very late production 4-control plexi-panel model (3-position rotary Selectone switch and pull for Bright on the Treble control).

[Updated on: Wed, 21 September 2011 08:08]

Report message to a moderator

Re: Selectone pre-amp PCB [message #13384 is a reply to message #13380]

Tue, 13 April 2010 06:49

stevem
Messages: 4745
Registered: June 2004
Location: NY

Senior Member

Are you looking to just put another board in it as a way to not have to find the electronic problem with yours?

Report message to a moderator

Re: Selectone pre-amp PCB [message #13386 is a reply to message #13384]

Tue, 13 April 2010 07:21

RobbieNuke
Messages: 66
Registered: October 2006
Location: Baltimore

Member

I actually have a K200B-4 (w/ Selective Boost and Harmonic Clipper on the right channel). The left channel is the plain vanilla unit (Volume/Bass/Treble pots w/ rotary Bright switch). I wanted to just swap PCB's so that I could use the 3-position Selectone circuitry. I play bass and find this particular tone circuit desirable, but I also like the Harmonic Clipper for fuzz bass effects as well. I assume it would be a simple swap... the controls should mount in the existing plexi panel locations and the wiring should not be too difficult either (DC supply in, audio out).

[Updated on: Tue, 13 April 2010 07:21]

Report message to a moderator

Re: Selectone pre-amp PCB [message #13387 is a reply to message #13380]

Tue, 13 April 2010 07:54

stevem
Messages: 4745
Registered: June 2004
Location: NY

Senior Member

You will need to drill the plexi front panel out for the new control location and to do that with out cracking the glass panel you need to use special bits for use in drilling plexiglass!

Report message to a moderator

Re: Selectone pre-amp PCB [message #13395 is a reply to message #13387]

Tue, 13 April 2010 18:24

RobbieNuke
Messages: 66
Registered: October 2006
Location: Baltimore

Member

Why would I have to drill new holes? If I'm removing the "normal" PCB altogether and substituting the selectone PCB in it's place control pots are all the same size/location. The left normal channel has only four controls (vol/bass/treble/brite) and the selectone has only four controls (vol/bass/treble w. pull bright and rotary selectone). I'm thinking of a reversible modification, not an additional PCB fitted in.

Report message to a moderator

Previous Topic:	Celestion Rocket 50's
Next Topic:	K250 bass amp issues

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Mon Jun 10 15:20:51 EDT 2024