I'm back at it again with a new project. I'm building a cloned K100-1 head chassis and cabinet. So far the cabinet is somewhat completed by my friend Don Diaz. He also did the metal chassis and I'm doing the stuffing. Using the parts laying around its going to be a full blown K250 with the K-III preamps. I gotta shrink down a copy of the K200A-1 face plate to fit the front yet.
Looks like just enough room for everything. I posted some pic's of the project so far at the link below
I just got the first go around at the face plate. Getting kind of crowded at the power light!!! I may have to relocate the power switch to the back and put the power light up top where the swich goes. Any ideas out there? I'm still working with the sizing and may be able to stretch it a little. See what it looks like with a face plate and knobs at the link below and share your thoughts. I'm trying to maintain the vintage Kustom look as much as posible.
Yes your right!!! I just made another template with a better fit. I removed the photo in the link and replaced it with 2 more of the new template. I did a little stretching and think I might have the room for all on front now. If your at all like me I never liked the switch in the back, it just didn't seem very handy back there. That was a K200B-1 Face plate I was imaging from because I needed the 2 channels with four controls on each channel to accomidate the pre-amps.