Home » VintageKustom.com » Comment Board » 2X15 verses 2X12 CTS Cab for guitar (Forgot to add on last topic)
2X15 verses 2X12 CTS Cab for guitar [message #17673] Thu, 15 November 2012 14:52 Go to next message
kustomhead is currently offline  kustomhead
Messages: 121
Registered: April 2012
Location: Redding, Ca
Senior Member
What about the difference between 2X15 and 2X12 CTS bass cabs for use with guitar?
Re: 2X15 verses 2X12 CTS Cab for guitar [message #17674 is a reply to message #17673] Thu, 15 November 2012 20:17 Go to previous messageGo to next message
Kustom_Bart is currently offline  Kustom_Bart
Messages: 601
Registered: October 2010
Location: Greenville, MichiGUN
Senior Member
the 2 x 15 is wider and is made for a K200 head and a 2 x 12 cab is shorter and narrower and is the same width as a K100 head. That is what they were both made for and the CTS are the same, I would still rather have Jensens at least for guitar, but the KEI's or CTS's sound good/ I really like the Altec and JBL speakers.

Bart
Re: 2X15 verses 2X12 CTS Cab for guitar [message #17675 is a reply to message #17674] Thu, 15 November 2012 23:54 Go to previous messageGo to next message
kustomhead is currently offline  kustomhead
Messages: 121
Registered: April 2012
Location: Redding, Ca
Senior Member
So the K150 head width matches the 70's 2X12 but not the 2X15 that goes with the 150's? The 150 head fits width wise on a K100 2X12 cab?
Re: 2X15 verses 2X12 CTS Cab for guitar [message #17676 is a reply to message #17675] Fri, 16 November 2012 00:31 Go to previous messageGo to next message
kustomhead is currently offline  kustomhead
Messages: 121
Registered: April 2012
Location: Redding, Ca
Senior Member
The K150-1&2 are 10 pleats wide and the K150-4 is 12 pleats wide. I just noticed that in the literature section.
Re: 2X15 verses 2X12 CTS Cab for guitar [message #17677 is a reply to message #17673] Fri, 16 November 2012 05:35 Go to previous messageGo to next message
sunnhead is currently offline  sunnhead
Messages: 221
Registered: June 2010
Location: Minnesota
Senior Member

You must mean the K250-4, they were bigger amps for the 250 series. The 150 amps only were available K150-1 and K150-2. Also the K150 and K100 series were 8 ohm driven amps. The 150 series 2x12's were 8 ohm cabinets. You should not use a 150 series amp with a 250 series cabinet, the 250 series cabinets were 4 ohm.


-Steve

[Updated on: Fri, 16 November 2012 05:35]

Report message to a moderator

Re: 2X15 verses 2X12 CTS Cab for guitar [message #17678 is a reply to message #17673] Fri, 16 November 2012 07:08 Go to previous messageGo to next message
stevem is currently offline  stevem
Messages: 4736
Registered: June 2004
Location: NY
Senior Member
You can use a k100 or metal face K150 with a K200/K250 cabinet, just do not play the amp at more than half volume and all should be well!
If you are giging outside on a really hot day I would place a small fan to blow on the back of the head.
Tech wise what is happening at the lower ohmage(4 load) is the output stage is putting out twice as much current and hence heat at 4 ohms as it would if a 8 ohm load was hook up.

Also the output stage(K150) will only pump out some 35 watts of clean power unlike the 75 watts it could do into 8 ohms.
So basically we are talking half the power and twice the heat load!
Re: 2X15 verses 2X12 CTS Cab for guitar [message #17679 is a reply to message #17678] Fri, 16 November 2012 09:20 Go to previous messageGo to next message
sunnhead is currently offline  sunnhead
Messages: 221
Registered: June 2010
Location: Minnesota
Senior Member

Yeah i guess your right there Smile Just to be safe though make sure you make your ohms safe.. no need to scorch a beautiful tuck and roll masterpiece!
Re: 2X15 verses 2X12 CTS Cab for guitar [message #17680 is a reply to message #17679] Fri, 16 November 2012 13:41 Go to previous messageGo to next message
kustomhead is currently offline  kustomhead
Messages: 121
Registered: April 2012
Location: Redding, Ca
Senior Member
Thanks for all the input! I've had every era of vintage Kustom amp and like my K150-2 above all. So for my K150-2 I need a 2 16 ohm speaker (wired in parallel) cab for a total of 8 ohms and with the 75 watt output I'm guessing a K100 2X12 8 ohm cab would handle the K150 power.
Re: 2X15 verses 2X12 CTS Cab for guitar [message #17683 is a reply to message #17680] Fri, 16 November 2012 15:06 Go to previous message
Kustom_Bart is currently offline  Kustom_Bart
Messages: 601
Registered: October 2010
Location: Greenville, MichiGUN
Senior Member
You are correct Smile
Previous Topic: 2X15 CTS Kustom cab for guitar
Next Topic: p-310 speaker tower
Goto Forum:
  


Current Time: Fri May 17 21:31:45 EDT 2024
.:: Contact :: Home ::.

Powered by: FUDforum 3.1.3.