Home » VintageKustom.com » Comment Board » Kustom PA Question. (How does it work.)

Show: Today's Messages :: Show Polls :: Message Navigator

Kustom PA Question. [message #18390] Tue, 12 March 2013 19:44   noshelter@live.com Messages: 36 Registered: January 2013 Location: Georgia Member I just got a K200-5 PA head.It has two out puts on the back. To use it for a guitar amp do I need two speaker cabs or can I use just one ? Thanks in advance for your help. Report message to a moderator

Re: Kustom PA Question. [message #18462 is a reply to message #18390] Wed, 20 March 2013 01:33 BC Messages: 583 Registered: March 2000 Location: Kentucky Senior Member The 200 series amps are looking for a 4 ohm load for maximum output. Does not matter what you use as long as you do not get below 4 ohms total. So, the choice is up to you and what sound you like. A single 8 ohm cabinet will cut the power a little but, it will work fine. Use two 8 ohm cabs to give a 4 ohm load and plenty of volume if that is what you want. You can use either output jack....or both if two cabs are used. BC Report message to a moderator

Previous Topic:	Output Transistors?
Next Topic:	70's Kasino bass rig

Goto Forum:

- VintageKustom.com  Comment Board  Replacement Part Suggestions  Repairing Kustom Amps- Classified Ads  For Sale  Wanted- FUDforum Questions & Problems  Questions & Problems about FUDforum