Home » VintageKustom.com » Comment Board » Kustom PA horn cabinet info
Kustom PA horn cabinet info [message #27293] Tue, 30 April 2019 18:08 Go to next message
braud357 is currently offline  braud357
Messages: 154
Registered: July 2010
Location: Louisiana
Senior Member
Do any of you have one of the Kustom "tuck & roll" PA horn cabinets (the kind that you put on top of a regular cabinet) This type had a horn similar to a Altec horn. What were the dimensions of this type of cabinet ? Thanks for any info !
Re: Kustom PA horn cabinet info [message #27294 is a reply to message #27293] Wed, 01 May 2019 06:09 Go to previous messageGo to next message
sunnhead is currently offline  sunnhead
Messages: 221
Registered: June 2010
Location: Minnesota
Senior Member

I have two o them, I can give the measurements hen I get a chance.
Re: Kustom PA horn cabinet info [message #27295 is a reply to message #27293] Thu, 02 May 2019 06:14 Go to previous messageGo to next message
stevem is currently offline  stevem
Messages: 4728
Registered: June 2004
Location: NY
Senior Member
Kustom started to use the Altec type horns in the K150 and 250 series of slant face amps .
If you go into the K150/250 literature section on this site you will in find a duel cabinet set up in black of a 250 series amp with the horn in it.
The cabinets where the same side width wise as a regular speaker cabinet for these amps, the height dimension of the needed cabinet would be what would provide the same horn to cabinet clearance as what you see in the picture on each side of the horn.

Kustom in that time frame also used the smaller type Altec horn As a option in the K150 cabinet along with one 15" driver.

[Updated on: Thu, 02 May 2019 12:15]

Report message to a moderator

Re: Kustom PA horn cabinet info [message #27296 is a reply to message #27293] Thu, 02 May 2019 07:54 Go to previous messageGo to next message
carlc is currently offline  carlc
Messages: 143
Registered: July 2006
Location: Summerville, SC
Senior Member
I think it is the same size as the earlier cabinet that had the two police siren horns. 22"x14"x11".
Re: Kustom PA horn cabinet info [message #27297 is a reply to message #27296] Thu, 02 May 2019 12:38 Go to previous message
pleat is currently offline  pleat
Messages: 1452
Registered: June 2004
Location: Belding, Mi
Senior Member
The Kustom Altec horn box is 14" tall, 24" wide and I'm not sure of the depth. The PA cabs from the 300/600 series cab are 54" tall x 24" wide. The guitar cabs of the 250/500 series are 46" tall x 24" wide. The single 15 + altec horn cab used the same horn as the guitar and PA cabs. Both height dimensions are without casters. You can go to the literature section and count the T&R which are 2" pleats.

pleat

Previous Topic: Question on cabinet for 150 head
Next Topic: K100 has no low end sound
Goto Forum:
  


Current Time: Thu Mar #d 14:08:38 EDT 2024
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.9.