Home » Classified Ads » Wanted » K250-4 Reverb Tank Assembly w/ Shockmounts and Locking Mechanism (Why would someone remove and discard it like that?)
K250-4 Reverb Tank Assembly w/ Shockmounts and Locking Mechanism [message #27310] Mon, 13 May 2019 14:03 Go to next message
Joe Tritschler is currently offline  Joe Tritschler
Messages: 2
Registered: May 2019
Junior Member
The title and topic description say it all; I have a K250-4 that is a great amp except the entire reverb assembly is missing. I even swapped in another 150-ohm tank and verified that all the electronic circuitry is working fine; why on earth would you do that to an innocent amp? Help would be greatly appreciated. I'd also be interested in a four-button light-up footswitch and wah pedal for said amp...sadly also gone.
Re: K250-4 Reverb Tank Assembly w/ Shockmounts and Locking Mechanism [message #27311 is a reply to message #27310] Tue, 14 May 2019 07:36 Go to previous message
stevem is currently offline  stevem
Messages: 4166
Registered: June 2004
Location: NY
Senior Member
Unles you find a donor 150 ,250 or 300 pa head these shock mounts are very hard to come by !

What I have done is to get 8 short machine screws and nuts and them embedded the screw heads in clears silicone bath tube sealer.
This is a two step process.
First I place a 1/4" dab of sealer on the head of a screw and then push another screw agonist it so that there is still 1/8" between the head of each screw.
Do this on wax paper and let it set up overnight, the next day pack more sealer around the 2 screw combo to retain them to each other better.
When you do the final Assy of the pan back in the amp do not tighten up the nuts too much or you will spin out the screws, but this method does work!

[Updated on: Tue, 14 May 2019 07:37]

Report message to a moderator

Previous Topic: Circuit board
Next Topic: Kustoms for sale
Goto Forum:

Current Time: Tue May #d 00:47:31 EDT 2019
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.9.