Home » VintageKustom.com » Repairing Kustom Amps » 250 Bass Amp Head (Removing electronics from amp head)
250 Bass Amp Head [message #28078] Fri, 05 March 2021 00:42 Go to next message
chemita57 is currently offline  chemita57
Messages: 3
Registered: March 2021
Junior Member
Do the small rivets on the sides of the rear panel of the amp head need to be drilled out to pull out the electronics?
Re: 250 Bass Amp Head [message #28079 is a reply to message #28078] Fri, 05 March 2021 05:33 Go to previous messageGo to next message
stevem is currently offline  stevem
Messages: 4728
Registered: June 2004
Location: NY
Senior Member
The complete chassis slides out the rear of the cabinet by removing the four 10/32 machine screws on the bottom of the cabinet, do not remove the 4 metal feed on the bottom if they are still there.

Do not drill out the riviets as they hold the chassis together . Why is it you need to gain access to the inside of the amp

[Updated on: Fri, 05 March 2021 05:37]

Report message to a moderator

Re: 250 Bass Amp Head [message #28080 is a reply to message #28079] Fri, 05 March 2021 10:23 Go to previous messageGo to next message
chemita57 is currently offline  chemita57
Messages: 3
Registered: March 2021
Junior Member
I need to clean out the pots and replace the bulbs. By the way, what size bulbs does this require.
Re: 250 Bass Amp Head [message #28085 is a reply to message #28080] Sat, 06 March 2021 09:34 Go to previous messageGo to next message
chemita57 is currently offline  chemita57
Messages: 3
Registered: March 2021
Junior Member
Thanks for the info. Now, where can I get the bulbs for the push button switches on the front panel?
Re: 250 Bass Amp Head [message #28086 is a reply to message #28078] Sat, 06 March 2021 11:37 Go to previous message
stevem is currently offline  stevem
Messages: 4728
Registered: June 2004
Location: NY
Senior Member
The bulbs are a number 335 and can be removed and installed from the front of the amp much easier then from the inside of the amp by using needle nose plyers to carefully remove the blue lens from the face of the switch.

Use some clear tubing to remove the old bulb and install the new one.

Do a search on line for the bulbs, I think I saw some on Amazon.
Previous Topic: Capacitor found in Kustom 200A Guitar Amp Cabinet
Next Topic: K100-2 Hiss
Goto Forum:
  


Current Time: Thu Mar #d 11:09:15 EDT 2024
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.9.