Smoke1 Messages: 107 Registered: September 2003 Location: Southern Maryland Solomon...
Senior Member
Anyone out there have a schematic for this 200B 5 PA Head SN: 39257? Dan? KustomBlues? Please send me instructions on how to get them if they are available to Smokemcnasty@hotmail.com. I looked thru the webboard and no one ever talks about this PA head? Would the Carvin 12" 8 or 16 Ohm speakers work in the cabinets best or what speakers would anyone recommend these days?
I'm mostly playing my guitar thru it and rarely use it for vocals anymore.
Smoke
Smoke1 Plays Kustom Amps & Old Tube Amps Loud in S. Maryland
stevem Messages: 4733 Registered: June 2004 Location: NY
Senior Member
Hi, If you like the sound of seven speaker I would get that 8th one reconed. Eight new speakers, all though their are better one out their would run you about 50 bucks each. I have schematics for the reverb board and the driver board, but not the front mounted preamp boards. Send me a self addressed stamped envelope to s magnotti 3273 elk ct yorktown hts. ny 10598.
Smoke1 Messages: 107 Registered: September 2003 Location: Southern Maryland Solomon...
Senior Member
Steven,
Thanks, mail is outgoing today. The 8th speaker hit the trash when it died in the 80's. Back then I didn't know speakers could be repaired and I installed a Sunn Beta lead speaker in its place and its been fine.
Does Anyone else out there have the pre-amp board schematics?
Where's Dan?
Thanks, Smoke
Smoke1 Plays Kustom Amps & Old Tube Amps Loud in S. Maryland
Smoke/Steven:
I think that the K200B PA pre-amp boards are the same as the normal pre-amp boards, PC105. The only difference is that the bright switch is replaced with the reverb control. So if you have it, a copy of the PC105 schematic should work.
Bill