|
|
Re: Schematics needed [message #11740 is a reply to message #11735] |
Thu, 03 September 2009 19:47 |
cassent5150
Messages: 341 Registered: August 2009
|
Senior Member |
|
|
lets see now, I've got 3 K-150-2's and 2 are fine other then the selectone switch issue thats common on all 3, but one of them channel 2 is out as well as the tremolo/vibrato is not oscilating. I have 3 K-200-5's one is fine, one has only a faint sound getting threw on all 4 channels and one has channels 1 and 2 working, but (3 and 4) just a faint sound getting threw. I have a Kasino 250 bass with a clipping problem when the volume is turned up past like 3 " this cold be my own fault, cause I replaced the KEI-1 009-5065-00 PC board with a 5065 out of a K-XII SRS tri amp. 2 Kustom XII-SRS Tri-amps, one is for parts. I've got a K-200-6 that works fine, a K-III 6 channel PA that works fine, one K-100-1 works fine, a Kasino U-100-P 4 channel head that has no signal getting to the driver board (the speakers don't pop when its turned on but they make that shhhhhhhh sound like the amp is on.but one of the two large power transisters on the driver board is heating up pretty good). 6 tuck n roll cabs 2=2x15, 2=2x15+horn,1 single 15, 1=2x12, I've got the K-4 Bass head, K-3 Lead head and 2 K-1501 tolex square PA roll cab's and a loaded cabinet I'm looking for a K-100 combo amp head to put in it. Yea I got some Kustom stuff STEVE
Steve C
|
|
|
|
|