Home » VintageKustom.com » Replacement Part Suggestions » Info About FLH-15 and M15

Show: Today's Messages :: Show Polls :: Message Navigator

Info About FLH-15 and M15 [message #17240] Wed, 27 June 2012 04:16   cato Messages: 1 Registered: June 2012 Location: Denmark Junior Member HEY I have purchased a Kustom FLH-15 front loading horn with a Rola driver and a M-15 top with Altec Horn and a driver where there is written: Kustom 832. what EV driver is that? What Bass driver can I replace the Tola driver with? JBL K130? JBL 2226H? Is the ROla driver 8 Ohm? Do anaybody have the original Dividing network plans? Cause my network is kind of homemade. Or anybody have som suggestions to a good network? How low does the FLH-15 go? Thanks... Report message to a moderator

Re: Info About FLH-15 and M15 [message #17241 is a reply to message #17240] Wed, 27 June 2012 08:08   pleat Messages: 1452 Registered: June 2004 Location: Belding, Mi Senior Member It's hard to tell after almost 40 years what might be in any of the cabinets. The FLH15 low cutoff is 40Hz with the original standard speaker and 35Hz with the EV (SRO version) speaker. The M-15 horn came with an Electro Voice 1823 driver. The crossover (?) a photo would help to determine if it is something that someone has added. Most Kustom horns use a simple capacitor 10Md as the crossover. As far as replacement speakers for the FLH cabs, you need to determine the amps impedance for a total load. If the amp runs max output at 4 ohm and the FLH are the only cabs, then you will want 8 ohm speakers for a 4 ohm total load, and the brand is really up to you. pleat Report message to a moderator

Previous Topic:	K200A footswitch?
Next Topic:	boost/wah pedal

Goto Forum:

- VintageKustom.com  Comment Board  Replacement Part Suggestions  Repairing Kustom Amps- Classified Ads  For Sale  Wanted- FUDforum Questions & Problems  Questions & Problems about FUDforum