VintageKustom.com: Comment Board » Interchangeable A series parts

Home » VintageKustom.com » Comment Board » Interchangeable A series parts ( Control spacing)

Show: Today's Messages :: Show Polls :: Message Navigator

Interchangeable A series parts [message #20193]

Wed, 19 February 2014 19:50

kustomhead
Messages: 121
Registered: April 2012
Location: Redding, Ca

Senior Member

Is a 4 channel K200 A series PA T&R case the same size as a K200 A-1 case and is the control spacing the same for both amps? Will a PA pre-amp and power PC board fit the hole spacing on the A-1?

[Updated on: Wed, 19 February 2014 19:53]

Report message to a moderator

Re: Interchangeable A series parts [message #20195 is a reply to message #20193]

Wed, 19 February 2014 21:50

pleat
Messages: 1452
Registered: June 2004
Location: Belding, Mi

Senior Member

Yes, all A series will fit the same head case and the spacing on all pre amp boards will fit any of the A series amps.
Kustom only manufactured one power amp for all the different models, A1 A2 A3 A4 and A5. If you owned a K200A-1 amp. The front panel has all 16 control holes punched into the front of the chassis and are equally spaced. The only difference is the black front control panel as to which model it was.
The A series and the B series the cases are different in depth and the A series uses 5 bolts to hold the chassis and has spacer blocks in the bottom inside of the head case.
pleat

Report message to a moderator

Re: Interchangeable A series parts [message #20197 is a reply to message #20195]

Thu, 20 February 2014 00:41

kustomhead
Messages: 121
Registered: April 2012
Location: Redding, Ca

Senior Member

Thank you for the info as always-Jim

Report message to a moderator

Previous Topic:	Kustom II Lead
Next Topic:	Lead III Cab Ports

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Apr #d 20:29:05 EDT 2024

.:: Contact :: Home ::.