VintageKustom.com: Comment Board » Need measurements for a K100 head case

Home » VintageKustom.com » Comment Board » Need measurements for a K100 head case

Show: Today's Messages :: Show Polls :: Message Navigator

Need measurements for a K100 head case [message #20558]

Mon, 05 May 2014 17:53

braud357
Messages: 154
Registered: July 2010
Location: Louisiana

Senior Member

Could anyone please help me - I am in need of the dimensions of a K100 head case - especially the measurements of the front opening and the overall depth. Thanks in advance !!

Report message to a moderator

Re: Need measurements for a K100 head case [message #20603 is a reply to message #20558]

Fri, 09 May 2014 18:37

stevem
Messages: 4733
Registered: June 2004
Location: NY

Senior Member

The case is made of I 1/2" ply.
The width of the inside rear is 19 1/8 th
The inside is 6 1/2" tall.
The inside depth is 10 inches, this is Measured from the inside of the fronts 3/4" smaller frame.
The front frame is 1/2 ply that is 3/4" tall all the way around the front.
This will let you I have 10 two inch wide pleats on top and four pleats of two inch down each side.
Wait, I need to I look again, I do not know if that front frame is set inside the case, or if the frame is 1 1/2" tall and set on the face of the case.
I will check and post back in the morning for ya.

[Updated on: Fri, 09 May 2014 18:41]

Report message to a moderator

Re: Need measurements for a K100 head case [message #20604 is a reply to message #20603]

Fri, 09 May 2014 18:48

braud357
Messages: 154
Registered: July 2010
Location: Louisiana

Senior Member

Thanks Steve !

Report message to a moderator

Previous Topic:	Newby dream amp turns out to be platypus. NEED HELP
Next Topic:	Looking for info on an old cab

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Thu Apr #d 15:42:14 EDT 2024

.:: Contact :: Home ::.