Received one of the amps I ordered and its in mint condition. Charcoal and not a scratch. You guys were right about what it actually was.....K200 series. On the back panel I know the RCA port is for a tape deck? What is the port right below it........reverb foot switch which of course I do not have. I am assuming this will still operate without the foot switch?
The idea of saving my 595 columns and using this amp to power the cabinets as monitors is what I am going with. Not sure as to what speakers to go with since there are 8 of them to replace.....$14 for economical ones or $35 plus for better ones....considering these will only be used as monitors. Need expert opinion here since these cabinets are going to cost me a mint to restore anyway.
Thanks again guys for all your help and info. This site is absolutely priceless and you guys are the greatest!!!!
Kustom_Bart Messages: 601 Registered: October 2010 Location: Greenville, MichiGUN
Senior Member
You honestly are better off to use the columns as monitors directly from your PA system. Otherwise you are going to have to run a line-out to the Kustom head and dial them in there and still have to run the line signal at the board. To many things to mess with for me. Yes it can be done, but I use the K.I.S.S. method.