JBL speakers [message #23057] |
Fri, 05 June 2015 23:38 |
Iowa Boy
Messages: 767 Registered: June 2014
|
Senior Member |
|
|
Another treasure snagged this week on my road trip......pair of JBL PA cabinets model 4265B. 15 inch speakers with the aluminum dust caps. Cabinet has a tweeter in it also as well as two bass ports. These things weigh a ton. Almost threw out my back carrying them down the stairs. I haven't opened them yet to see what speakers they actually are as far as speaker model, but was wondering if they could not be used in my one bass cabinet that has CTS speakers. These cabinets are rated at 200 watts RMS at 8 ohms. These things are built like a tank! Real neat parallel jacks on the back so you can run another cabinet off the one. If they won't work for bass, thought I'd put them in one of my 2-15's with siren cabinet for PA. Any thoughts? Thanks.
|
|
|
|
|
Re: JBL speakers [message #23063 is a reply to message #23057] |
Sat, 06 June 2015 11:11 |
Iowa Boy
Messages: 767 Registered: June 2014
|
Senior Member |
|
|
Guess I'm not sure how you check polarity with the battery....guess that I always thought if there was a red terminal, that was positive. So are you saying that if you put the battery on the posts one way and the speaker doesn't move, then turn the battery the other way and it does move....by looking at the battery you will now know which post is positive?
[Updated on: Sat, 06 June 2015 11:15] Report message to a moderator
|
|
|
|
Re: JBL speakers [message #23065 is a reply to message #23057] |
Sat, 06 June 2015 12:39 |
chicagobill
Messages: 2005 Registered: April 2003
|
Senior Member |
|
|
The polarity only is a problem when two or more speakers are connected another at the same time with reversed polarities. As long as all of the speakers that are connected to one amp all push and pull at the same time there is no problem.
So mixing a JBL cabinet and a CTS cabinet could be tricky if they aren't correctly wired. You would lose all bottom end from the sound.
|
|
|
|
|
|
Re: JBL speakers [message #23076 is a reply to message #23070] |
Sun, 07 June 2015 14:43 |
chicagobill
Messages: 2005 Registered: April 2003
|
Senior Member |
|
|
The first time I learned about the problem of out of phase speakers was back in the early '70s. A gut I knew of mine loved the sound of Voice of the Theater cabinets and built two of them to use for a PA system for his band.
He couldn't afford the Altec speakers, so he used a pair of Utah 15" speakers. He installed the two speakers and loved the sound of each of the cabinets, but something was wrong when he used both of them together. After testing everything and tearing out a lot of hair, he finally did a battery polarity test and found that one of the two speakers was wired wrong from the factory.
I guess the assembler just picked up the voice coil and installed it upside down, reversing the polarity. Once he reversed the wiring to the one speaker, all was well.
|
|
|
|
Re: JBL speakers [message #23085 is a reply to message #23057] |
Mon, 08 June 2015 08:48 |
C4ster
Messages: 686 Registered: June 2001 Location: Mukwonago, WI (Milwaukee...
|
Senior Member |
|
|
Hi, I did a little research on your JBL cabinets. They are the second version of the Cabaret series speakers in the 80's. JBL did not market them as PA speakers but as a complete system for small bands. Stage monitors, bass cabinets, sub-woofers, keyboard and vocals. The model you stated were bass cabinets. With the volume that these cabinets were, the E140 speakers in them sounded great. But JBL did reuse the same cabinet for multiple configurations to allow the users to stack different cabinets. Similar to Kustom in that regard. I have 2 Cabarets with E130's that I routinely use for PA in small venues in a 2 way system. I also have E140's loaded in 3x15 siren cabinets that I love. But, the "newer" sirens with the 2 metal ports sound MUCH better than the earlier 4 2" ported pa cabinets. Go with the E140's, you won't be disappointed.
Conrad
|
|
|
|
Re: JBL speakers [message #23088 is a reply to message #23086] |
Mon, 08 June 2015 10:44 |
C4ster
Messages: 686 Registered: June 2001 Location: Mukwonago, WI (Milwaukee...
|
Senior Member |
|
|
Where are you located. You've mentioned Wisconsin in a couple of posts. IA is not that far away. If you have a price in mind for the cabs, I might load those with E130's and a ring radiator for my small setup. PM me.
Conrad
|
|
|