Anyone have any suggestions on where/if you can find replacement feet for the bottoms of the Kustom amps? These are the 4 round chrome feet with the screw in the middle.
How many do you want? I take them off all my amps since they leave marks on the speaker cabinets. I don't see the need for them if the amp is sitting on the speaker anyway. In time they rust and leave rust marks on the cabinets.
Thanks for the offer but I ordered 4 new ones for $4.35 with free shipping. I think they are better left on. Those chassis screws will tear the naguhide if not covered by something. The feet keep the amp off of those screws.
All my amp heads have the recessed rounded screw heads on them. No way they can damage the T&R. I have had one that had bolts in it which I assumed were not original so I replaced them with the rounded stainless steel ones.
The screws are 8/32 round head phillip screws with a washer under them. I do suppose that if you tighten them up enough you can get them below the level of the naguhide, but then you risk cutting the naguhide with the washer. The situation I am talking about is when someone uses an electric driver to remove or put the screws in you can bugger up the phillips head slot and leave a rather sharp lip on those screws. You will find similar situations on the back cover of the speaker cabs where someone had let the driver hop out of the Philips slot and bugger the screw up and create a sharp edge. If you are careful then there are no problems.