Home » VintageKustom.com » Repairing Kustom Amps » Troubleshooting Custom Challenger Amp (Repair)
Troubleshooting Custom Challenger Amp [message #26442] Thu, 21 December 2017 20:20 Go to next message
suthvid is currently offline  suthvid
Messages: 1
Registered: December 2017
Location: New Bedford, MA
Junior Member
I'm trying to troubleshoot a Kustom Challenger amp. I don't know thw vintage but the SN is 94130. It belongs to my daughter and it was DOA when I received it. No power light, no humming electronics, no tnothing. I'm not a service tech but I have good troubleshooting skills and a volt/ohmeter.

Where do I start?

Thanks!


Thanks,
John

[Updated on: Thu, 21 December 2017 20:21]

Report message to a moderator

Re: Troubleshooting Custom Challenger Amp [message #26443 is a reply to message #26442] Fri, 22 December 2017 00:09 Go to previous messageGo to next message
chicagobill
Messages: 2005
Registered: April 2003
Senior Member
Welcome to the place.

If there is no sign of life at all, the first place to start is to check the fuse and the ac wiring. Take your ohm meter and hold the two leads to the hot and neutral prongs of the ac plug. Next turn on the amp and see if you get any reading. If the fuse is still intact and the wiring to the power transformer is all as it should be you should get a reading under 100 ohms.

If you get no reading (your meter displays the same as if the leads are not touching anything) you will need to check the fuse. Remove the chassis from the cabinet and look for the fuse, which is soldered in place. Visually inspect it and test it with your meter.

If the fuse is blown, you have a problem with the amp and you will need to troubleshoot the power supply and the power amp. If the fuse is good, then you will need to test the power switch and all of the wiring starting with the ac cord and the internal wiring to the fuse and the internal thermostat.

If you go to the technical section of this site, you will find the schematic for your amp which will help you to trace the ac primary wiring.

Again, welcome.
Re: Troubleshooting Custom Challenger Amp [message #26444 is a reply to message #26443] Fri, 22 December 2017 08:23 Go to previous message
stevem is currently offline  stevem
Messages: 4728
Registered: June 2004
Location: NY
Senior Member
according to your serial number your amp was born between July and Dec of 72.
Previous Topic: K200 B-1 LF oscillation
Next Topic: Tantalum Capacitors sub w/ Aluminum Electrolytics?
Goto Forum:
  


Current Time: Thu Mar #d 18:20:52 EDT 2024
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.9.