Home » VintageKustom.com » Repairing Kustom Amps » Kombo II Parts (Looking for Parts source for Kombo II )
Kombo II Parts [message #26770] Fri, 22 June 2018 13:39 Go to next message
Trumpet Man is currently offline  Trumpet Man
Messages: 2
Registered: June 2018
Location: Arkansas
Junior Member
Greetings all.

I browsed the posts in this forum for my topic and did not have any luck. So here is my issue.
I have a 1974 Kombo II that is in pretty good condition, except the mouse family that lived in it for a short while before I bought it left some corroded traces on the Summing Board. There is about 12" of surface trace that I am remediating or jumper bypassing. The C keys have a deficit in the first generation tone signal. A couple of transistor pairs and their resistors are bad and I'm replacing.

However, does anyone have a supply of old stock boards for these that anyone is aware of?

Thanks,
Trumpet Man
Re: Kombo II Parts [message #26771 is a reply to message #26770] Sat, 23 June 2018 06:40 Go to previous messageGo to next message
stevem is currently offline  stevem
Messages: 4728
Registered: June 2004
Location: NY
Senior Member
sorry to say that I think your only hope is a donor kombo II .
That being said , we have the schematics here on the site so I can't see why you can't just hard wire it and use some bread boards if nessary to get it back up and running, yes I agree it' sounds like a project, but it's doable!

[Updated on: Sat, 23 June 2018 06:43]

Report message to a moderator

Re: Kombo II Parts [message #26772 is a reply to message #26771] Sat, 23 June 2018 20:22 Go to previous message
Trumpet Man is currently offline  Trumpet Man
Messages: 2
Registered: June 2018
Location: Arkansas
Junior Member
Thanks. I have the schematics and the maintenance manual and I am in the process of replacing parts and surface jumper installation. I would be interested in a donor Kombo II if one was out there.

Thanks.
Previous Topic: Reverb but no tremolo
Next Topic: KUSTOM VIII S-R-S amplifier
Goto Forum:
  


Current Time: Thu Mar #d 16:58:35 EDT 2024
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.9.