Home » VintageKustom.com » Replacement Part Suggestions » Altec driver replacement (Emminence PSD 2002-8/16)
Altec driver replacement [message #27579] Sun, 10 November 2019 08:56 Go to next message
johnnysynth is currently offline  johnnysynth
Messages: 45
Registered: June 2018
Member
This emminence driver handles 80W with frequency response of 1.2K to 20K
It probly bolts right up to an Altec 811B horn which
looks like what was in the old T&R cabs equiped with HF drivers.
Don't really know what Bud used for a crossover. The
Altec brand would have probly been a N800-D 800hz unit.
I'm going to try this out myself so I thought I'd put this
idea out here for discussion. The mystery is. . .what X-over
to use?
I'm trying to'PUT' one
of these cabs together from separate modern parts
to wind up with the original T&R cab but with
JBL K130's and one of these modern Emminence drivers.
By theory at least it should kick ass.
Jake Welsh- johnnysynth@yahoo.com
Re: Altec driver replacement [message #27580 is a reply to message #27579] Sun, 10 November 2019 15:35 Go to previous messageGo to next message
pleat is currently offline  pleat
Messages: 1452
Registered: June 2004
Location: Belding, Mi
Senior Member
The altec horn uses screw on drivers. Kustom used a simple 4mf cap on the siren cabs and the altec horns they used 10mf cap. The 10mf would cross around 1K and the 4mf crosses around 2K.
pleat
Re: Altec driver replacement [message #27581 is a reply to message #27580] Mon, 11 November 2019 07:41 Go to previous messageGo to next message
johnnysynth is currently offline  johnnysynth
Messages: 45
Registered: June 2018
Member
Thanks for the info about the HF drivers/crossovers. Did they use an Altec 806 driver coupled to the 811B horn?
If they did, that would have required a pretty deep cab to accomodate that set-up. I'm looking for
the original T&R cab that had two 15's and the sectoral horn used with the 250-4 amp. I have the
250-4 (black) and it's fantastic. Can't wait to couple it up with the right speaks.
Jake Welsh
johnnysynth@yahoo.com
Re: Altec driver replacement [message #27583 is a reply to message #27581] Mon, 11 November 2019 15:53 Go to previous message
pleat is currently offline  pleat
Messages: 1452
Registered: June 2004
Location: Belding, Mi
Senior Member
kustom was using Atlas PD5VH mid drivers and eventually switched over to the EV 1823 mid driver when Kustom became the EV distributor for microphones and speakers.

pleat
Previous Topic: 3055 vs 3771 power transistors
Next Topic: Hustler Reverb Tank
Goto Forum:
  


Current Time: Thu Mar #d 13:55:32 EDT 2024
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.9.