Home » VintageKustom.com » Replacement Part Suggestions » Kpm160 mixer (reverb tank replacement)
Kpm160 mixer [message #28289] Mon, 02 August 2021 20:31 Go to next message
TheAnimal is currently offline  TheAnimal
Messages: 1
Registered: August 2021
Junior Member
I have a kpm160a mixer and the reverb tank is toast. I can't find the Belton model that was in it. What can I use for a replacement? Bsn2ebe1a.
Re: Kpm160 mixer [message #28290 is a reply to message #28289] Tue, 03 August 2021 05:53 Go to previous messageGo to next message
stevem is currently offline  stevem
Messages: 4728
Registered: June 2004
Location: NY
Senior Member
Hello and welcome.
Unfortunately this site does not have info for such a new model as you have there.
I would suggest that you get in contact with the customer service dept at the current Kustom company for assistance.
Re: Kpm160 mixer [message #28316 is a reply to message #28289] Thu, 02 September 2021 13:22 Go to previous message
chicagobill
Messages: 2005
Registered: April 2003
Senior Member
Yes, welcome.

I searched for Belton tank codes and went to the Belton website and downloaded the pdf for the BS-series tanks.

B=Stands for Belton
S=Stands for small size
N=New version
2=Two springs

The rest of the codes are for input and output impedance, etc. There seems to be a problem with the code that you wrote down, as it doesn't conform to their format. Is there a space (blank) in the code?

In any case, you should be able to figure out enough from the specs listed at the site to match an available tank.

Good luck.
Previous Topic: K300 power transformer
Next Topic: Legend Amplification replacement knobs
Goto Forum:
  


Current Time: Thu Mar #d 16:49:46 EDT 2024
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.9.