Home » VintageKustom.com » Comment Board » III Lead Amp impedance
III Lead Amp impedance [message #28489] Tue, 05 April 2022 07:52 Go to next message
diy-sound-guy is currently offline  diy-sound-guy
Messages: 2
Registered: April 2022
Junior Member
We have a Kustom III Lead amp to use in the backline of our venue. There is no information about the the impedance anywhere on the back of the amp. It is a standalone amp, not the combo variant.

I have searched but did not find any info on the net. Does anyone have any idea?

Thank you in advance.
Re: III Lead Amp impedance [message #28490 is a reply to message #28489] Tue, 05 April 2022 11:26 Go to previous messageGo to next message
stevem is currently offline  stevem
Messages: 4739
Registered: June 2004
Location: NY
Senior Member
Welcome to the joint!
For that to output its full 125 Watts of rms it will want a 4 ohm load which it was designed for.

It will as any SS will run fine with a 8 ohm load, but only output some 78 watts of rms power.

[Updated on: Tue, 05 April 2022 11:28]

Report message to a moderator

Re: III Lead Amp impedance [message #28491 is a reply to message #28490] Tue, 05 April 2022 11:31 Go to previous message
diy-sound-guy is currently offline  diy-sound-guy
Messages: 2
Registered: April 2022
Junior Member
Thank you. This is all the information I need.
Previous Topic: Kustom K150-8
Next Topic: K150-8 noise issues
Goto Forum:
  


Current Time: Sun May 26 01:30:27 EDT 2024
.:: Contact :: Home ::.

Powered by: FUDforum 3.1.3.