VintageKustom.com
VintageKustom.com is your source for literature and information on the tuck-and-roll vintage Kustom amps from the 60's and 70's, as well as their related products such as guitars and organs . We provide a webboard for help with kustom gear history, technical information and repairs as well as discussions with other collectors.
Today's Messages (on)  | Unanswered Messages (off)

Forum: Repairing Kustom Amps
 Topic: Kustom 100 PA head CHASSIS SCREW SIZE
Kustom 100 PA head CHASSIS SCREW SIZE [message #29342] Thu, 26 September 2024 05:47
backlineguy is currently offline  backlineguy
Messages: 17
Registered: November 2023
Junior Member
Hello all,

I just acquired a Kustom 100 4-channel PA head in very good condition ( the tuck and roll is beautiful Charcoal), but the chassis screws are not the correct size...apparently whomever replaced the power cord with a grounded plug either lost them, or they were wrong to begin with...anyone out there know the correct screws needed to secure this sucker?
Thank you in advance for your help!

Report message to a moderator




Current Time: Thu Sep 26 08:39:04 EDT 2024
.:: Contact :: Home ::.

Powered by: FUDforum 3.1.3.
Copyright ©2001-2023 FUDforum Bulletin Board Software