Today's Messages (on)  | Unanswered Messages (off)

Forum: Wanted
 Topic: Kustom speaker system cab 2L+1H
Kustom speaker system cab 2L+1H [message #27582] Mon, 11 November 2019 08:20
johnnysynth is currently offline  johnnysynth
Messages: 32
Registered: June 2018
Member
The (2L) part of the designation refers to two JBL 15" D130f's
The (1H) part of the designation refers to one Altec HF driver

I have a K250-4 amp already so I'm looking for a black T&R cab
with or without the speakers in it. It has to be the right
cab though. . .deep enough to fit the Altec horn. I play
electric piano through this rig so that's why I need the
top end clarity with the Altec horn! Even if you just
have the a tall black T&R cab (the one that went with
this speaker compliment only) then I would buy that.
If you have one WITH speakers. . .even better!
Jake Welsh
johnnysynth@yahoo.com
Forum: Replacement Part Suggestions
 Topic: Altec driver replacement
Re: Altec driver replacement [message #27581 is a reply to message #27580] Mon, 11 November 2019 07:41
johnnysynth is currently offline  johnnysynth
Messages: 32
Registered: June 2018
Member
Thanks for the info about the HF drivers/crossovers. Did they use an Altec 806 driver coupled to the 811B horn?
If they did, that would have required a pretty deep cab to accomodate that set-up. I'm looking for
the original T&R cab that had two 15's and the sectoral horn used with the 250-4 amp. I have the
250-4 (black) and it's fantastic. Can't wait to couple it up with the right speaks.
Jake Welsh
johnnysynth@yahoo.com
Re: Altec driver replacement [message #27583 is a reply to message #27581] Mon, 11 November 2019 15:53
pleat is currently offline  pleat
Messages: 1410
Registered: June 2004
Location: Belding, Mi
Senior Member
kustom was using Atlas PD5VH mid drivers and eventually switched over to the EV 1823 mid driver when Kustom became the EV distributor for microphones and speakers.

pleat



Current Time: Mon Nov #d 16:53:36 EST 2019
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.9.