Today's Messages (on)  | Unanswered Messages (off)

Forum: Repairing Kustom Amps
 Topic: 250 Bass Amp Head
250 Bass Amp Head [message #28078] Fri, 05 March 2021 00:42
chemita57 is currently offline  chemita57
Messages: 2
Registered: March 2021
Junior Member
Do the small rivets on the sides of the rear panel of the amp head need to be drilled out to pull out the electronics?

Report message to a moderator

Re: 250 Bass Amp Head [message #28079 is a reply to message #28078] Fri, 05 March 2021 05:33
stevem is currently offline  stevem
Messages: 4361
Registered: June 2004
Location: NY
Senior Member
The complete chassis slides out the rear of the cabinet by removing the four 10/32 machine screws on the bottom of the cabinet, do not remove the 4 metal feed on the bottom if they are still there.

Do not drill out the riviets as they hold the chassis together . Why is it you need to gain access to the inside of the amp

[Updated on: Fri, 05 March 2021 05:37]

Report message to a moderator

Re: 250 Bass Amp Head [message #28080 is a reply to message #28079] Fri, 05 March 2021 10:23
chemita57 is currently offline  chemita57
Messages: 2
Registered: March 2021
Junior Member
I need to clean out the pots and replace the bulbs. By the way, what size bulbs does this require.

Report message to a moderator




Current Time: Fri Mar #d 11:09:09 EST 2021
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.9.