Today's Messages (on)  | Unanswered Messages (off)

Forum: Repairing Kustom Amps
 Topic: K150-6 pumps out DC voltage when powered on.
Re: K150-6 pumps out DC voltage when powered on. [message #27684 is a reply to message #23707] Tue, 25 February 2020 07:20
stevem is currently offline  stevem
Messages: 4253
Registered: June 2004
Location: NY
Senior Member
Forgive my oversite here, but you have a early model K150, and I have been looking at the schematic for a late K150 model with the 5033 board.

The early model 150s like yours still use the K100s +8 and -8 volt regulator sections and preamp section, so besides Q5 maybe going bad as the issue, something in that + 8 volt regulator circuit could be the bottom line on your issue maybe?

To narrow this down when the amp acts up check to see if your + 8 volts ( red wire to preamp boards) is still 8 volts when you have that 27 volts on the output.

By the way you do not need to keep a speaker load hooked up once the issue starts, this will save your ears and speakers!

[Updated on: Tue, 25 February 2020 07:22]

Report message to a moderator

Re: K150-6 pumps out DC voltage when powered on. [message #27685 is a reply to message #23707] Tue, 25 February 2020 09:47
corybrown is currently offline  corybrown
Messages: 27
Registered: August 2015
Junior Member
Yeah, I unplug the speaker any time the hum comes back. I really only have it plugged in when I'm checking to see if it's working and how long it will work.

I got some better rated test leads and will check those when I get home this evening.

Thanks again.



Current Time: Tue Feb #d 10:32:18 EST 2020
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.9.