Home » VintageKustom.com » Repairing Kustom Amps » Kustom PA50 (Need Info, schematic, speaker specs., etc.)
Kustom PA50 [message #11154] Mon, 08 June 2009 14:28 Go to previous message
IvyR is currently offline  IvyR
Messages: 3
Registered: June 2009
Location: Michigan
Junior Member
I am troubleshooting a Kustom PA50 mixer/amp that I would like info regarding specifications, schematic, and speaker specs. I am thinking this is a mono unit and the two speaker 1/4" jacks on the back are for two speakers in parallel...but I could be wrong. Are these 16, 8, 4 ohm or what impedance speakers? Label says not to go lower than 4 ohms. Is that for each jack (speaker)or for total combined?
 
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: 6 Pin Footswitch for Kustom k250-4 Wiring
Next Topic: Model 1-B /SE540L driver chip
Goto Forum:
  


Current Time: Wed Dec #d 17:07:01 EST 2020
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.9.