VintageKustom.com: Repairing Kustom Amps

Home » VintageKustom.com » Repairing Kustom Amps » Kustom PA50 (Need Info, schematic, speaker specs., etc.)

Show: Today's Messages :: Polls :: Message Navigator

Kustom PA50 [message #11154]

Mon, 08 June 2009 14:28

IvyR
Messages: 3
Registered: June 2009
Location: Michigan

Junior Member

I am troubleshooting a Kustom PA50 mixer/amp that I would like info regarding specifications, schematic, and speaker specs. I am thinking this is a mono unit and the two speaker 1/4" jacks on the back are for two speakers in parallel...but I could be wrong. Are these 16, 8, 4 ohm or what impedance speakers? Label says not to go lower than 4 ohms. Is that for each jack (speaker)or for total combined?

Report message to a moderator

[Message index]

		Kustom PA50 By: IvyR on Mon, 08 June 2009 14:28
		Re: Kustom PA50 By: stevem on Tue, 09 June 2009 05:47
		Re: Kustom PA50 By: IvyR on Tue, 09 June 2009 10:37
		Re: Kustom PA50 By: stevem on Tue, 09 June 2009 12:12
		Re: Kustom PA50 By: IvyR on Sun, 14 June 2009 13:08

Previous Topic:	6 Pin Footswitch for Kustom k250-4 Wiring
Next Topic:	Model 1-B /SE540L driver chip

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

]

Current Time: Thu Sep 19 14:49:56 EDT 2024