VintageKustom.com: Comment Board

Re: K150 and BC PA Qs [message #7922 is a reply to message #7921]

Tue, 12 December 2006 13:07

Bikerboy
Messages: 7
Registered: December 2006
Location: South Coast, England

Junior Member

Thanks for getting back to me.

The K150-2 has dual voltage with a selector on the back. Serial number is 94695 if that helps any. The switches are badly damaged. Yes, they are broken where they attach to the little bracket as you say but also the blue bit is gone from the front and there is only a little piece of the white sleeve left. I can poke a screwdriver in there to get the microswitch to go on/off but that wouldn't be the smartest thing I ever did. The little lamps are still there and light up OK.

The mixer is still a mystery then. I think it is probably mono (no pan controls) no clip lights, no ohm marking on speaker outputs which are on top of the unit, no sliders.
Each channel has:
XLR LoZ & jack HiZ inputs with selector switch
PAD 0 - 10 - 20 (whatever the hell that is)
Rotary controls for Level, Lo Eq, Hi Eq, Reverb, monitor
then there is master for volume, reverb and monitor.
It also has two 'power amp in' jacks, and jacks for Expander main,monitor,echo, Echo send/receive, Main out, Monitor out. Serial number is K200456 if that helpsanyone to ID it.

Bikerboy

Half Man, Half Vegetable, Half Wit

Report message to a moderator