VintageKustom.com: Repairing Kustom Amps

Re: Kustom PA50 [message #11158 is a reply to message #11154]

Tue, 09 June 2009 05:47

stevem
Messages: 4733
Registered: June 2004
Location: NY

Senior Member

Hi, this is a latter model Kustom than the vintage stuff we noemally deal with here. I have helped many folks with schematic for the vintage stuff but am unable to hhelp you out with that model.
If you go to the new Kustom amplification site and request a schematic for that model from their service dept, they can email you one.

The amp is mono, so its designed for two 8 ohm cabinets which would make for a total load of 4 ohms.
From what I have seen of these small type PA heads they use output packs that are cheap and easy to replace, as I am betting that although you did not post what your problem is, that is the PAs problem, no output.

Report message to a moderator